Mini Submersible Pump / Fountain Pump Module
Horizontal mini submersible pump with MOSFET drive — GPIO or PWM speed control for fountains and plant watering.
- Material
- PCB & electronic components
- Age range
- 8+
- Category
- STEM Robotics & Electronics
- Customisation
- OEM & ODM available
Specifications, component counts and packaging are configurable. Figures shown reflect our standard configuration.
Key features
- Horizontal mini submersible pump driven by an on-board MOSFET — high level runs, low level stops.
- PWM speed control adjusts rotation speed and therefore water flow.
- Note: the circuit board is not waterproof — never submerge it completely.
Frequently asked about this product
How do I connect the Mini Submersible Pump / Fountain Pump Module to my controller board?
The Mini Submersible Pump / Fountain Pump Module uses the standard 3-pin GVS (Ground-VCC-Signal) interface with an XH2.54 connector, so it plugs straight into Arduino UNO, ESP32, micro:bit and our sensor shields with a regular sensor cable — no soldering required. It works with Arduino IDE, Mixly, Mind+, Scratch and mBlock.
What voltage does the Mini Submersible Pump / Fountain Pump Module run on?
The Mini Submersible Pump / Fountain Pump Module has separate logic and load supplies: the logic side takes 3.3-5 V from the controller, while motors or high-current outputs are fed from their own 5-12 V supply through the dedicated power terminal. Never power the load side from the controller’s 5 V pin.
What projects is the Mini Submersible Pump / Fountain Pump Module good for?
The Mini Submersible Pump / Fountain Pump Module is built for STEM and robotics education: classroom demonstrations, science-fair projects, robotics club builds and competition robots. It pairs with the rest of our module range — same connectors, same voltage, same toolchain — so students move from first circuit to competition robot without changing platforms.
What certification do the robotics and electronics products carry?
Controller boards, sensors and modules ship with CE marking and RoHS-compliant components, and the range is designed for classroom use under teacher supervision. Product-specific test reports and declarations of conformity are available for distributors on request.
What is the minimum order quantity, and can I get a sample first?
These are standard catalogue lines with stable production, so minimums are low and lead times are short. Samples ship within about a week and are normally credited against a first order. Mixed-SKU cartons are accepted for evaluation orders.
Related products
Need pricing on this line?
Send your target quantity, destination market and any changes you need to artwork, colourway or packaging. We reply with a quotation and the applicable compliance route — usually within one working day.