MQ-2 Gas & Smoke Sensor
MQ-2 smoke and gas sensor with analog output — works with Mixly, Arduino, Scratch and mBlock.
- Material
- PCB & electronic components
- Age range
- 8+
- Category
- STEM Robotics & Electronics
- Customisation
- OEM & ODM available
Specifications, component counts and packaging are configurable. Figures shown reflect our standard configuration.
Key features
- Detects smoke and specific gases: the input value changes sharply when gas approaches the probe after warm-up.
- Analog output for concentration-style readings from any ADC pin.
- Compatible with Mixly, Arduino, Scratch, mBlock and other programming environments.
- New revision updates the module size and removes the potentiometer — functionality unchanged.
Frequently asked about this product
How do I connect the MQ-2 Gas & Smoke Sensor to my controller board?
The MQ-2 Gas & Smoke Sensor uses the standard 3-pin GVS (Ground-VCC-Signal) interface with an XH2.54 connector, so it plugs straight into Arduino UNO, ESP32, micro:bit and our sensor shields with a regular sensor cable — no soldering required. It works with Arduino IDE, Mixly, Mind+, Scratch and mBlock.
What voltage does the MQ-2 Gas & Smoke Sensor run on?
The MQ-2 Gas & Smoke Sensor runs from a standard 3.3-5 V DC supply (USB or the controller’s 5 V rail). It draws only a few milliamps in normal operation, so it is safe to power from the controller board itself for classroom builds.
What projects is the MQ-2 Gas & Smoke Sensor good for?
The MQ-2 Gas & Smoke Sensor is built for STEM and robotics education: classroom demonstrations, science-fair projects, robotics club builds and competition robots. It pairs with the rest of our module range — same connectors, same voltage, same toolchain — so students move from first circuit to competition robot without changing platforms.
What certification do the robotics and electronics products carry?
Controller boards, sensors and modules ship with CE marking and RoHS-compliant components, and the range is designed for classroom use under teacher supervision. Product-specific test reports and declarations of conformity are available for distributors on request.
What is the minimum order quantity, and can I get a sample first?
These are standard catalogue lines with stable production, so minimums are low and lead times are short. Samples ship within about a week and are normally credited against a first order. Mixed-SKU cartons are accepted for evaluation orders.
Related products
Need pricing on this line?
Send your target quantity, destination market and any changes you need to artwork, colourway or packaging. We reply with a quotation and the applicable compliance route — usually within one working day.